Okay.. .lots of details since the last update. I fiberglass taped the chine edges and removed the 2x which was holding the chine flat.

I fiberglass taped the inside shelf edges and filleted them as well as finished filleted the chine side edge where the temp blocking had been installed to screw the side panels to.

I cut off, sanded and glassed the edges where the side panels met the transom. I then put a 10 oz glass layer on the transom.

I also filled the myriad scrw holes in the side panels and sanded everything down.

This all totalled several partial days so this should really encompass two days worth of updates

Feb 28, 2006

Tape port chines .


Page 1 , last page , next page