N .

Jan 10, 2008

Fuel Fill


Page 1 , last page , next page

The holidays are over and we've changed direction for a bit by finishing the fuel fill site in the splash well. I built a chase around the fuel fill & vent hoses.
I realized the top has to be removeable and there needs to be a side panel in order to tighten the hose connections once the lid is on.

This is how I resolved to do it.

The "lid is canted down 5 degrees so water can't collect on it. The lid and side panel will be screwed in place using caulking as the "adhesive". This way in the future these parts can be inspected or repaired if necessary .

The vent cap has not been tightened in place since lid & panel still need epoxy. That's why it's crooked in the pcs.

.